Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 8/27/2005 2:49:51 PM EDT
Do I have to remove the buffer ?DO RR tubes come off OK or are they a bear. I could allways spend a bit more and get one that just locks on using a screw.
Link Posted: 8/27/2005 2:55:01 PM EDT
I think it's easier to just take off the buffer tube. Don't lose your buffer pin, when you back out the tube it will go flying. You may be able to leave it on with an a2 stock, but I think you have to take it off with a colapsing stock. In any case it is not hard at all. Check the build it yourself section, they have detailed instructions on how to take them apart and put them together.
Link Posted: 8/27/2005 2:56:18 PM EDT
[Last Edit: 8/27/2005 4:35:53 PM EDT by Mr10anahaf]
OK cool I checked the BIY section and did not see anything , I'll check again. Thanks
Link Posted: 8/27/2005 2:56:37 PM EDT
Installation should be OK assuming they don't use Red loktite or stake the nut.

Try to use a decent wrench (no $5 cheapies) and take your time,
so the buffer detent or selector spring don't go flying!
Link Posted: 8/27/2005 3:23:29 PM EDT

Originally Posted By GhostRing:
Installation should be OK assuming they don't use Red loktite

Close. RRA uses blue Loctite but heck, you can loosen that stuff up with a hair dryer.
Top Top