Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 3/27/2006 9:11:26 AM EDT
I used a kit to finish my stripped lower, I was really impressed by how easy it was, but now I am thinking I might have screwed something up.

The pin that the trigger rided on was moving and was working its way out of the receiver about every 20 rounds. The hammer spring should keep it in place, but I guess its just not holding it? Too much CLP in that area???

Any fixes for this?
Link Posted: 3/27/2006 9:15:45 AM EDT
YES!


Your hammer spring is in backwards.



Your welcome
Link Posted: 3/27/2006 9:17:37 AM EDT
is it suppose to go underneath the pin? rightnow its on top?
Link Posted: 3/27/2006 9:20:29 AM EDT
Link Posted: 3/27/2006 9:21:26 AM EDT
Here ya go:


http://www.ar15.com/content/guides/assembly/lower/#hammer



Just like that, when you pull yours out and compare it to the picture; you will then understand that you had it in backwards......No biggie.
Link Posted: 3/27/2006 9:38:56 AM EDT

Originally Posted By Ineedhelp:
Here ya go:


http://www.ar15.com/content/guides/assembly/lower/#hammer



Just like that, when you pull yours out and compare it to the picture; you will then understand that you had it in backwards......No biggie.



oh thanks now I get it,

funny part is the gun ran pretty good, had a couple of light strikes on the first mag and then it ran fine???
Top Top