Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 10/13/2018 11:49:48 AM EDT
I got the Holosun riser for my 510C so that I can have 1/3 cowitness. Im looking for torque values for the screws to mount it and I cant seem to find them on any Holosun sites or literature.

Does anyone know or have experience on them? Also, did you dab a little blue Loctite when you did them?
Link Posted: 10/13/2018 2:05:41 PM EDT
[Last Edit: 10/13/2018 2:06:49 PM EDT by Capt_Destro]
I don't have torque values.

Heres what I do for just about everything:
I used blue loctite.
I tightened the screws using the L key long ways until they were snug.
Afterwords I gave them a quarter turn with the other end of the L. Don't hamfist it at this point.

I only hold the L key with 3 fingers and try to put the least amount of force into it as possible. I do have a screwdriver set with various allen/torx heads, but it's too easy to over torque with something like that.
Top Top