Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/19/2017 7:27:10 PM
Posted: 12/15/2005 1:44:12 PM EDT
I want to mount a sling adapter to my M4LE, but the locking ring on the buffer tube was staked
at the factory. I have the lower in a mag well vice block, but I can't seem to budge the locking ring
with a wrench. I considered tapping the wrench with a hammer, but I'm afraid it will put too much
presure on the mag well and screw it up. So, what do I do?

Thanks
Link Posted: 12/15/2005 2:28:02 PM EDT
Try harder.

It should shear off that little piece of steel without damaging anything else.

WIZZO
Link Posted: 12/15/2005 3:25:35 PM EDT
I managed to get it loose. DAYUM, that was hard!
Link Posted: 12/15/2005 5:17:30 PM EDT
I had the same problem with my Bushmaster. I used a hammer on the wrench to try to break it loose and ended up breaking the wrench tooth off. I finally was able to lossen the nut with a hammer and punch. It did ruin the buffer tube by messing up a couple of treads on it. Once the nut was loose I just backed it off and it came right off. I was replaceing the tube anyway as it was not mil spec and would not work with my new Vltor stock.
Top Top