Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 6/19/2003 8:06:21 AM EST
Does anyone have a link or is there a thread to diassemble a lower to replace the parts? I already have instructions to assemble the parts.
Link Posted: 6/19/2003 8:28:53 AM EST
Disassembly was fairly easy. BUT, I can't get the frigin' selector back in over the trigger. Any suggestions?
Link Posted: 6/19/2003 8:38:01 AM EST
DONT. put the selector in first. then put in the brass selector "pin" and spring. install the pistol grip. now put in the trigger
Link Posted: 6/19/2003 8:49:38 AM EST
GREAT..It's in. I guess I have a set of bad directions. Thanks
Link Posted: 6/19/2003 10:02:50 AM EST
Just wondering?? Did you read the instructions first?? Or you like me sometimes and try it without reading??
Link Posted: 6/19/2003 10:29:51 AM EST
I only had instructions for assembling the parts, "So You Want to Build an AR-15". Not sure where I got them. I had to perform the steps in reverse for the disassembly, then I could proceed using the instructions. BUT, the instructions stated to put in the trigger and hammer before the selector. It work fine with the selector in first. It should be a piece of cake next time.
Link Posted: 6/19/2003 12:40:39 PM EST
These are much better instructions; [url]ar15.com/content/docs/assembly/lower/[/url]
Link Posted: 6/19/2003 12:51:09 PM EST
Even these instructions say to put the trigger group in before the selector. Backwards, no???
Link Posted: 6/19/2003 3:10:21 PM EST
There are many slightly-out-of-spec triggers which will not permit the selector to slide in over the trigger with the hammer installed, so you have to do selector first, then trigger. It's a small thing, but with truly in-spec parts you can install as indicated in either set of directions.
Top Top