Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 10/27/2003 11:55:37 AM EST
Poly-Dunk-Kit or Dunk-Kit

I saw it on a rerun of American Shooter. I don't have any polymer pistols, but I suppose that I might get one someday. For now, would it be best to get just the Dunk-Kit? Or is the Poly-Dunk-Kit the same as far as a regular blued pistol?

Is either one hard on rubber or wood pistol grips? Leather or cordura holsters? Ammo?

Any hints on how to use it on long guns like the AR?


Link Posted: 10/27/2003 8:27:11 PM EST
A couple of the guys over at hkpro.com swear by it, but I've never tried it personally.
Link Posted: 11/4/2003 10:04:40 PM EST
Much cheaper and easier solution: Mix up some Ed's Red (if you don't know what it is, it's home-made bore cleaner, and good at that). http://www.geocities.com/Yosemite/Gorge/4653/edsred.htm Then, put it in a big bucket. Remove plastic grips or wood (let's face it, if it's a decent cleaner, it'll eat up both those). Then, let it soak in the barrel. I put mine on a mesh strainer turned upside down in the tank so it doesn't sit in settled gunk. Take out, blast clean and whala - clean gun. After a while, strain the solution through a terry towel to clean it, and it'll last pretty much forever.
Link Posted: 11/5/2003 2:36:09 AM EST
With the amount of plastic around now days deep inside one's firearm, would consider leaving out the acetone (plus help reduce the chance of fire). I have been using a mixture of low odor mineral sprits and a little ATF (5 to 10% or 1 quart in four gallons), however, lube afterwards.
Top Top