Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 5/20/2003 3:06:31 AM EST
I have an Essential Arms Pre Ban that hase been great for the past 12 years or so....BUT..now I find that the hammer pin seems to be walking out towards the left side of the reciever....and when the hammer gets to a certain angle it creates a 2 shot burst....Is there any type of locking pin??? I really don't want to scare the guys at the range...
Link Posted: 5/20/2003 3:25:13 AM EST
You can try anti-walk pins, they should fit the hammer also. [url]http://bushmaster.com/shopping/lowers/we-002.asp[/url]
Link Posted: 5/20/2003 3:33:43 AM EST
Check your hammer to see if the J-pin is still in place. It's a small J shaped pin that fits up into hammer to hold it on the pin. If it is in place try a new hammer and pin next. DSA has the best anti-walk pins if you need to go that route.
Link Posted: 5/20/2003 5:05:46 AM EST
[Last Edit: 5/20/2003 5:06:18 AM EST by M4arc]
I agree with ARK15, check the J-Pin. I had one break about 3-4 weeks ago. The pin kept walking out the left side. Took it apart and noticed that I could not see the J-Pin when I looked through the hammer pin hole. Ordered a new hammer and life is fine! Here's my thread on the troubleshooting board: [url]http://www.jobrelatedstuff.com/forums/topic.html?b=3&f=66&t=158652[/url] Hope this helps
Link Posted: 5/20/2003 6:21:10 AM EST
thanks guys....
Top Top