Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 7/8/2012 3:24:09 PM EDT
[Last Edit: 8/28/2012 7:22:28 AM EDT by fordkicksass]
Link Posted: 7/8/2012 3:47:14 PM EDT
Link Posted: 7/8/2012 4:28:30 PM EDT
Yep, your hammer is no good. The bottom part of the hammer, where it is caught by the nose of the trigger, the area is either worn or ground away.

Sounds like the disconnector is catching correctly because the hammer is caught when the trigger is held to the rear. This tilts the disconnector up into catching the hammer hook.

When the trigger is not pulled to the rear, it is caught by the "sear" surface at the front "nose" of the trigger were it rides into the very small notch cut into the bottom of the hammer.

You may just want to replace both trigger & hammer at the same time to ensure you start fresh
Link Posted: 7/8/2012 5:00:50 PM EDT
[Last Edit: 8/28/2012 7:23:10 AM EDT by fordkicksass]
Link Posted: 7/8/2012 7:36:49 PM EDT
Link Posted: 7/9/2012 6:26:09 AM EDT
Thanks I'll try working the disconnector to see if it for sure moves freely tonight after work.
Link Posted: 7/9/2012 2:21:20 PM EDT
[Last Edit: 7/9/2012 2:22:52 PM EDT by Big-Bore]
Top Top