Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/19/2017 7:27:10 PM
Posted: 4/4/2006 11:44:54 PM EDT
I am having a problem with a vulcan v15 lower and a new custome built del-ton upper. I can close the lower and upper receiver, though it is kinda tough. I can and put the take down pin in place, but it is hard as hell to get it all the way in. You can see through the upper and lower, cause there is a really small gap. I cannot pull the bolt back, the charging handle wont move at all. I am unsure how to go about this problem because of the bolt issue. In the past I have had this problem and to fix it I simply filed the pivod pin an the take down pin a bit and everything was fine, but I never had this problem with the bolt not moving.

Any ideas? I can send pics if needed.

Link Posted: 4/5/2006 6:45:05 AM EDT
sounds like something is outta spec....i'll put my money down that its the vulcan lower

pls post pics here if you can

btw: you are not using a accuwedge, are you?

Link Posted: 4/5/2006 8:08:45 AM EDT
will post pics asap, no not using an accuwedge. And I know your right about the lower. The upper works fine on my other lower.
Link Posted: 4/5/2006 10:49:57 AM EDT
Hesse monkeys....
Link Posted: 4/5/2006 11:35:13 AM EDT
[Last Edit: 4/5/2006 11:35:41 AM EDT by blacklisted]
Why did you get a Vulcan when there are so many others out there?

Vulcan/Hesse doesn't exactly have a stellar reputation.
Top Top