Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
11/22/2017 10:05:29 PM
Posted: 9/13/2004 12:04:26 PM EST
Want to thread my barrel and figure if I can remove the front sight, then I can chuck it in may lathe. Looks like the gas tube cross pin and two pins on the bottom of the front sight assembly need to be removed. Does it come off easily or is there a special tool needed? Should I forget it and just take the barrel off.
Link Posted: 9/13/2004 1:54:56 PM EST
Read through the following thread. It is a relatively hard task but it can be done.

FSB Removal
Top Top