Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 7/21/2003 5:15:14 PM EST
I decided to venture into my bolt & carrier some, and I pulled the retaining pin for the firing pin, and when I went to reinstall it, the damn thing gave me all sorts of troubles, the legs would spread out and not go into the other side when I would put it in. Is there a easier way to get it to go back in?
Thanks
Link Posted: 7/21/2003 6:14:37 PM EST
You dont want the legs to be 110% together, but you dont want them spread too far apart as well. One mm can be plenty of gap. Some can just be a regular PITA sometimes....Murphy I guess....A nice small bag of extra parts is VERY handy, throw theold one in the bag, try another one. Try twisting/turning as you insert... YMMV....
Link Posted: 7/21/2003 6:21:25 PM EST
I insert mine so that the end of the pin is vertical and then I give the bottom leg a little nudge with the end of a wooden 6" Q-tip or a small allen wrench. It works like a charm for me. I just gave up in trying to insert it and twist!
Top Top