Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
10/20/2017 1:01:18 AM
9/22/2017 12:11:25 AM
Posted: 9/25/2005 9:35:42 AM EDT
I want to try and go with the low profile PRI gas block w/set screws. This way I can use the Troy CQB suprsr. Is it ok to just leave the taper pin holes empty or should I plug them back up with the taper pins and mill them flush w/ the barrel? It's just a structural integrity question.. they'll both be covered by parts so I won't see them anyway... Thnx
Link Posted: 9/25/2005 11:12:24 AM EDT
The new gas block will cover them, and the holes won't weaken the barrel any.
Link Posted: 9/25/2005 12:17:30 PM EDT
Thnx much M4..... I've got a Commmando setup now and I plan on getting the PRI w/ a midlength FF tube from YHM. That TROY CQB suprsr will recess back inside the FF an inch....... very SD-ish. Do I have to cut a flat spot in the barrel for the set crews or no?
Top Top