Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 1/2/2006 12:12:41 PM EST
First off, thanks for looking in this thread and any helpful comments that you may have..................

I am in the process of building up a SBR 9mm and have a question in regards to the FSB. I have removed the standard front sight and am looking foreward to cutting the barrel down to just longer than the front handgards. I will probably be putting an EOTech or JP for the main sight, but would still like to put backups on it. I suppose that I should mention that it is a flat top upper with a YHM free floating front hand guard on it. What I need to know is, can I buy a back up front sight that fits on a FSB and have it be the correct height to work with the rear sight. Or do I have to get a special height front sight? Is a front gas block the same height as the YHM front hand guard?


Thanks,
Nox
Link Posted: 1/2/2006 12:50:13 PM EST
Link Posted: 1/2/2006 5:58:10 PM EST
Yes, I have removed the front sight from the barrel. Since there is no gas block to bolt anything to, I need to bolt it to the forward hand guard. My question is will a standard one made for a gas block work with the front hand guard or do i need a special height one?


Nox
Link Posted: 1/2/2006 7:10:04 PM EST
Link Posted: 1/2/2006 11:39:12 PM EST
None. It's a 9mm upper. Straight blowback. Not gas operated.
Link Posted: 1/3/2006 3:05:28 AM EST
Link Posted: 1/3/2006 7:17:53 AM EST
What hole?
Link Posted: 1/4/2006 8:16:59 PM EST
There should be no hole on a 9mm barrel. If you cut the barrel just short of the rail, then you'll need a rail mounted sight unless you left just enough room for an FSB...

TS
Top Top