Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
11/22/2017 10:05:29 PM
Posted: 9/20/2004 5:44:29 PM EST
I have never had trouble removing this roll pin until now. This one roll pin in particular will not come out. I have damaged 2 roll pin puches (one from Lyman and one from Brownell's just to let you know the Lyman's one is much stonger) and have not been able to budge the pin. Any suggestions on how to get it out? I will try anything. I have already gone nuts and started to dremel off the gas block (bushmaster milled) but stopped b/c I did not want to damage the barrel b/c I had the wrong size cutting attachment. Should I try a propane torch? Let me know what you think.
Link Posted: 9/20/2004 6:07:40 PM EST
[Last Edit: 9/20/2004 6:08:11 PM EST by SBR7_11]
I asume you wish to remove the barrel..... just "knock" the (2) sight base pins and move the gas block/sight base forward enough to un-tube the barrel nut.
Link Posted: 9/20/2004 6:10:12 PM EST
That is a great idea and did not even thik about it before I started cutting on the gas block. I did try to take ot the pins but could not. Maybe I will order the tool from Brownell.s to do it.
Link Posted: 9/21/2004 4:10:00 AM EST
[Last Edit: 9/21/2004 4:11:12 AM EST by silverc]
ADCO sells a tool to remove the gas tube roll pin. It was around $5 and works well. It is not very effective at driving a new pin back in to replace the one you took out. I was able to drive it halfway in, and then had to use a small nail to finish the job.
Top Top