Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 3/17/2006 4:07:37 PM EST
[Last Edit: 3/18/2006 8:52:08 AM EST by SpudZ19D]
Hey guys just wondering if anyone has done it, and how good the finish held up. I havent got my barrel yet, just wantin to be prepared. I plan on puttin a YHM flip sight on it. I figure i can slide the FSB down to the M4 cut in the bbl (after i tape it a little) and then dremel it off carefully. Any thoughts/suggestions appreciated! Got it off, thanks guys!
Link Posted: 3/17/2006 4:39:06 PM EST
Where you getting barrel from. Sometimes you can jus order a raw barrel without FSB and its cheaper.
Link Posted: 3/17/2006 10:16:35 PM EST
[Last Edit: 3/17/2006 10:19:02 PM EST by JL7]
Link Posted: 3/18/2006 3:47:32 AM EST
so all you want to do is replace the fsb? i would probably do it as you plan to, cut it over the m4 step.
Top Top