Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 2/27/2006 6:23:17 PM EST
[Last Edit: 2/27/2006 6:24:57 PM EST by JJREA]
Some of you may have seen it, but I had a thread about me debating on putting an A1 stock on my carbine. When I use my 6 position stock I have it in the 4th position out and it's 9-3/4" long from butt to reciever. It's perfect for a squared off stance and doesn't put my face too far forward in prone. I just wanted to get an exact measurement to see if it would work for me. Thanks in advance for any help. It would be going on this carbine:

Thanks again, yall

FWIW, the picture show's it in the 3rd position out or 1 closer in then I'm talking about.
Link Posted: 2/27/2006 7:31:19 PM EST
My late-A1 stock (with butt-trap) is exactly 10 inches. I'm not sure if there is any difference in the earlier A1 stocks without the butt-trap.
Link Posted: 2/27/2006 8:20:27 PM EST
My pre A1 stock with the solid rubber buttplate is 9 7/8" long.
Link Posted: 2/28/2006 3:19:23 AM EST
Well, that's almost the same. I may have to try it. The only question is, I wonder if the recoil impulse will change, due to the rifle spring and buffer. Because it's very smoooooth right now.
Link Posted: 2/28/2006 6:43:07 AM EST
I made a spacer out of aluminum, that I put inside of the rifle length buffer tube so that the carbine spring an buffer could be used. Just measure the depth of the rifle and carbine tubes on the inside where the spring sits. The difference between the two, is how long your spacer needs to be.
My spacer looks like the letter I, and is cut down to 1/2" in the middle for weight savings. The O.D. is around .980". I also drilled an 1/8" hole through it lengthwise, so there is still a clear path for water to escape through the hole in the buttstock screw.
I am using a Wolfe extra power buffer spring, with an H2 buffer. Its a sweet shooter.
It has a 14.5" M4 1/7 chrome lined barrel, with a permanent Phantom FH, A1 upper with Fwd.Assist and Deflector, with a pre A1 stock. I chose the early stock because of the rubber buttplate. It doesn't slip when shooting prone.
Link Posted: 2/28/2006 7:09:35 AM EST
A1 stock is 9 7/8".
Top Top