Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 9/3/2004 5:12:08 AM EST
Do I need a special wrench to install the correct stock on my rifle? Looking forward to getting my LEGP to more accurately resemble an actual M4.
Link Posted: 9/3/2004 2:17:02 PM EST
Link Posted: 9/3/2004 3:27:57 PM EST
I would recommend the three pin type. The single type pin only slightly reduce your chances of marking it up. However, the single pin type will work if you are only going to slightly tighten and count on locktite to do the work.
Link Posted: 9/3/2004 5:07:50 PM EST
Considering that a RRA M4 wrench is only $6, it's a very small investment. Works great.
Link Posted: 9/3/2004 6:54:53 PM EST
It is called the Castle nut wrench and it would be of great assistance since you need to get it tight, also if you try to use a screw driver like others have you will end up with a nasty little crimp on your nut.
Top Top