Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
11/24/2017 4:44:23 PM
11/22/2017 10:05:29 PM
Posted: 9/13/2004 12:06:41 PM EST
Going to be building a DEA carbine clone over the next few months and wondering if I should go with RRA or DPMS parts. RRA would make for an authentic clone, but DPMS would save a few bucks. I'm familiar with the finish on the DPMS lowers, etc...but how does it compare to the finish on RRA receivers?
Link Posted: 9/13/2004 12:11:27 PM EST
i had an RRA upper on a DPMS lower and the finish was almost identical. either should work.
Link Posted: 9/13/2004 1:49:04 PM EST
Really? I thought the DPMS finish was a bit rougher...more comparable to an Oly lower. On the other hand, I was assuming that the RRA finish was more like a Knight's rifle.

ANyone else?
Link Posted: 9/13/2004 2:05:51 PM EST
i've had 4 or 5 dpms lowers and none have been rough. same with the oly lower i had. all are great IMO except hesse/vulcan.
Link Posted: 9/13/2004 2:20:17 PM EST
I use Colt parts with Colt guns, RRA with RRA, BM with BM.
Link Posted: 9/13/2004 2:31:58 PM EST
DPMS cheaper than Rock River??? Not around here, where RR lowers are significantly less expeneive than DPMS. Check out the prices on RR lowers on the EE section of this site.

Oh BTW, the DPMS lower I have, while not badly finished, is nowhere near as good as on the two Rock River pieces I have.
Top Top