Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Posted: 1/10/2005 12:00:21 PM EDT
I am interested in installing a A.R.M.S. SIR. I'd like to go with the M model but don't know how difficult it is to remove the deltal ring. Anyone out there know a step by step instruction to remove the delta ring.
thanks
Link Posted: 1/10/2005 12:11:02 PM EDT
JUst carefully dremel through one side of it. Use a flathead screwdriver to pop the Delta Ring in half and remove it. Grab the weld spring with a pair of vice grips and pull it off.....same with the handguard snap ring. That should do it.

It's a little Wile E.Coyote I know but it worked for me on three carbines so far
Link Posted: 1/10/2005 12:25:49 PM EDT

Originally Posted By VTDefender:
JUst carefully dremel through one side of it. Use a flathead screwdriver to pop the Delta Ring in half and remove it. Grab the weld spring with a pair of vice grips and pull it off.....same with the handguard snap ring. That should do it.

It's a little Wile E.Coyote I know but it worked for me on three carbines so far



That works and is recommended by Troy for their MRF.

The other way is to remove the barrel and slide the parts off the end.
Link Posted: 1/10/2005 12:30:54 PM EDT
VTDefender's method worked for me also. I was told how to do it by SMGLee.
Link Posted: 1/10/2005 12:31:50 PM EDT
More completely innocent parts soon to die the horrible Dremel death.
Link Posted: 1/10/2005 12:36:59 PM EDT
If you were close by I'd change it out for you cause I can always use a spare delta group.

Danny
Top Top