Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Posted: 5/8/2005 3:04:50 PM EDT
[Last Edit: 6/2/2005 2:37:11 AM EDT by COKrinkster]
Delete thread please
Link Posted: 5/8/2005 4:03:35 PM EDT
[Last Edit: 5/8/2005 4:04:57 PM EDT by viper5194]
It sounds like your referring to the hole that holds the spring and tiny detent for the selector. The one thats drilled from the rear of the receiver .. If so, im not really sure how you could tig weld it unless you havent drilled it all the way thru. If its drilled all the way into the selector hole then there would be no way for you to get the entire hole filled with any type of welding. Since the hole is mainly concerned with alightment and doesnt take any stress I would try to fill it with some type of industrial epoxy useing a syringe so that you could fill the entire length of the hole since its nearly an inch long or so. Once hard most good epoxies can be drilled and hold up very well. Thats about the best i can come up with. I would make sure to let the epoxy cure fully andthen some...
Link Posted: 5/8/2005 4:44:16 PM EDT
Try J&B weld epoxy its a 2 part epoxy that can be drilled and machined after it is cured. I heard its some good stuff try your local hardware store.
Link Posted: 5/8/2005 5:48:28 PM EDT
JB weld would work, BUT you would definetly have to put it in a needle type device to get it all the way into the hole... We're talking a tiny hole, about a 1/16" or so and near 1 inch long/deep...
Link Posted: 5/8/2005 7:58:21 PM EDT
use the jb weld, and work it in with finger pressure, it should force it in little by little....you can force that stuff in a surprising distance just by rubbing back and forth, and adding a bit as you go...
Link Posted: 5/21/2005 9:53:56 AM EDT
[Last Edit: 6/2/2005 2:36:48 AM EDT by COKrinkster]
Delete thread please
Link Posted: 5/21/2005 1:09:56 PM EDT
Glad to hear it worked out. As small as the hole was and as unimportant as it really is I figured it would do ok to use the epoxy.

Top Top