Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
10/20/2017 1:01:18 AM
9/22/2017 12:11:25 AM
Posted: 10/6/2005 2:11:37 PM EDT
I am in the process of installing a Bushmaster Superlite barrel on an A-2 receiver. I am ready to install the A-2 Flash Hider the washer is concave on one side convex on the other, which way is correct or does it matter?
When I ordered this barrel Bushmaster said it would take 4-6 weeks, it came in 3 weeks to the day.
It was just like Christmas only better, because there is no snow.
Thanks for the help.
Link Posted: 10/6/2005 2:15:59 PM EDT
i install mine with the concave towards the flashider
Link Posted: 10/6/2005 4:02:33 PM EDT
Ditto, though I still like peel washers better!
Link Posted: 10/6/2005 5:41:12 PM EDT
I got it done, the middle slot hit about 12:30 when hand tight. I squashed the washer in a vice this was pretty slow going until I got Western with it then it went pretty quick. I found an earlier post which also helped.
Thanks again.
Top Top