Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 11/24/2003 5:02:14 PM EST
Anyone have any experience/thoughts about drilling out a small hole hammer, trigger and disconnector to the large pin size. I think there is only about .015 difference. I was going to pull the retaining springs back on the hammer and trigger, then drill in a press. The reason for this is I already have a 9mm Colt lower kit, but it is the earlier ones with the small holes, and dont want to spend 80 bucks to replace it if I don't have to.
Also, who has the large hole trigger and hammer pins?
Link Posted: 11/24/2003 6:29:12 PM EST
Brownells, just don't drill it...
Link Posted: 11/24/2003 6:58:30 PM EST
[Last Edit: 11/24/2003 7:00:38 PM EST by Raptor22]
If I am not mistaken, all you have to get is a large pin hammer. With the spring it is around $30. The trigger and disconnector are the same in both calibers. You should have no problem selling the small pin set.
Top Top