Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/19/2017 7:27:10 PM
Posted: 10/25/2002 8:22:39 PM EDT
I currently have a Reflex II for my Bushmaster on the RX06-10 (M-16 base) mount and it works great. However, when I transfer it to my OLY 9MM A2 upper it will not fit. The internal dimensions of the carry handle where the RX06-10 slips into is too tight.

I am now looking at getting a Compact ACOG w/M16 base and want to know if I am going to have the same issues? Does anyone out there have an ACOG on an OLY A2 Upper that works or has also had this problem?

Link Posted: 10/26/2002 7:20:14 AM EDT
Oly's dimensions are off. Take some calipers and measure. If it ain't .500" it ain't good to go. I had the same problem a few years ago with a TA01 and Oly A2 upper. Send the upper back to Oly and tell them you want one with an internal dimension of .500". Like a Bushmaster!
Link Posted: 10/26/2002 7:36:24 AM EDT
[Last Edit: 10/26/2002 7:36:38 AM EDT by Paul]
I found that my Olympic Arms upper had it's hole drilled too far aft to mount a gooseneck forward carry handle mount to it.

Sounds like they get it almost right
Link Posted: 10/27/2002 5:11:53 AM EDT
I have the same problem with a Reflex carry handle mount in an Oly handle. (Oly seems to have many problems with tolerances) I coated the mount with grease and lightly tapped it in with a plastic hammer. Their dimensions are off, but not by much.
Top Top