Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 9/3/2003 6:18:18 PM EDT
I would like to know exactly how to install a collapsible stock. I haven't been able to find any instructions. I am planning to install one on a M11/9 carbine. Here is the link to the adapter piece that I am oredering http://www.stonycreekarmory.com/products_pages/stonycreek_products_M11.htm. I am getting the Post-ban AR stock adapter. I don't want any complications with this piece. Also, I would like to state that I know the laws, concerning post-bans. Thanks for the help.
Link Posted: 9/3/2003 6:23:59 PM EDT
I can't personally answer your question but the link you posted above does not work. Here is the link that you intended to post: [URL]http://www.stonycreekarmory.com/products_pages/stonycreek_products_M11.htm[/URL] Hope that helps,
Link Posted: 9/4/2003 5:52:57 AM EDT
It's pretty simple. In your case, just screw it in , line it up vertically, then tighten the lock ring. On an AR there are considerations such as screwing the stock in far enough to retain the buffer detent and installing the buffer, and getting the takedown pin detent and spring installed under the keeper plate, but I doubt any of that will apply with a M11.
Link Posted: 9/4/2003 7:27:34 AM EDT
Bottom of this page; [url]ar15.com/content/docs/assembly/lower/[/url]
Top Top