Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 3/3/2006 4:28:57 PM EST
I did a search and couldn't find. How do I change the black followers with the new Mag Pul followers?
Link Posted: 3/3/2006 4:31:58 PM EST
Use a flat head screw driver to pry the floor plate off be careful of the spring pressure.Wiggle out the spring and follower and the mag pul will slip right back in,green followers have to be played with but the mag pul lines up perfect with the bottom of the mag just look how the spring is attached to the old follower and do the same to the new one.
Link Posted: 3/3/2006 4:33:41 PM EST
Roger. Wilco. Out.
Link Posted: 3/3/2006 4:37:24 PM EST
Link Posted: 3/3/2006 4:44:44 PM EST
[Last Edit: 3/3/2006 4:50:57 PM EST by pun]
I never said to mess with the tabs..unless some ones retarded you can see where to pry from...under the angled part of the rear of the floorplate..who said anything about screwing with the tabsalso THE TABS ARE PART OF THE MAGAZINE NOT THE FLOOR PLATE.So be careful not to bend the tabs on the bottom of the magazine.
Link Posted: 3/3/2006 4:53:50 PM EST
[Last Edit: 3/3/2006 4:57:43 PM EST by HeavyMetal]
Link Posted: 3/3/2006 6:56:42 PM EST
I use a phillips in the hole in the floor plate.
I can't imagine not using the hole in the floor plate, why make life harder?
Link Posted: 3/3/2006 7:11:17 PM EST
Thanks guys. I'm a retired 19D but I can follow directions. I managed to change 10 mags to the orange Magpul followers. In 24 years of the army I used to just DX mags that didn't work. To clean them we would go to the AMSA shop and blow them out with an air gun. That worked really well and those that didn't work we would just DX. Thanks for the info.
Link Posted: 3/4/2006 4:28:11 AM EST
Do this...

Then this...


Add in some...
Top Top