Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 2/2/2006 4:59:23 PM EST
I bought a upper a while ago and was under the impression that it was pinned, but there were threads under. So I took the brake off today, and NO threads. So I am wondering if it is still possible to thread the barrel, with the intent of installing a suppressor, or should I just sell off the barrel and get a threaded one?
Link Posted: 2/2/2006 5:11:36 PM EST
It can be threaded. Adco has a good rep. for barrel work.
Link Posted: 2/2/2006 5:21:10 PM EST
Roughly, how much am I looking at paying? If it is anything significant, I can just get a new barrel.
Link Posted: 2/2/2006 6:05:25 PM EST
ADCO Thread job www.adcofirearms.com/shopservices.cfm?page=shop

$65 plus shipping both ways
Link Posted: 2/2/2006 8:52:53 PM EST

Originally Posted By AKsRule:
ADCO Thread job www.adcofirearms.com/shopservices.cfm?page=shop

$65 plus shipping both ways

im sure its very good service, but that is a little more than i can spend right now anyways. maybe ill just stick with the brake for now.
Link Posted: 2/3/2006 7:30:07 AM EST
brownells has a new tap guide you stick in the muzzle. you start your die down on the prethreaded guide and it protects the muzzle, bore and alignment while starting the die for you.

the die and guide cost @ $40 i think. when you were down, if you've taken care of them i'd bet you could resell them on the EE and recover most of the money...

septic tank

Link Posted: 2/3/2006 11:30:07 AM EST
The barrel must be turned down to .495 -.500 x .625 before you can use a threading die if thats the route you want to take. PATRIOT ARMORY 07 FFL
Link Posted: 2/3/2006 12:45:42 PM EST
yep, bbl. must be turned down so that the die will fit over the muzzle to thread and even then the threads have a great chance of not coming out straight with the bore which will cause the muzzle device to cock to one side and possibly obstruct the bullet's path.

cheaper and safer to have it done professionally.
Link Posted: 2/4/2006 7:08:57 AM EST
The barrel diameter has to be correct +/- a couple of thousandths for the 1/2"-28 thread. I have the die, but I only use it to clean up existing threads. I've seen some hand-cut barrel threads and, while functional, they weren't pretty. Lathe-cut threading is the right way to do it.

I have the lathe and tooling if you are interested. Please IM or email for info.
Link Posted: 2/6/2006 11:02:40 PM EST
[Last Edit: 2/6/2006 11:03:23 PM EST by AR15barrels]
Top Top