Got my five SS mags today. They look FAN-FREAKING-TASTIC! I won't get to test them for a while, so I'll leave that to others, but they look and fit great. OK, all you with some time to do some shooting let me know if I have any surprises (which I strongly doubt) so can I go ahead and order the 6.8 mags!
eta:
I did some work with the mags tonight and noticed that all 5 of my mags had very sharp edges along the weld line (which I first noticed when that edge sliced my finger!). Also, all of them had burrs that would cut you if you were not careful. I presume that the metal when sheared during forming left a razor edge along the front and rear edges and at each weld spot there was a flashing thrown out from under the seam between the top and bottom halves in the weld area. These little burrs would catch the cloth I was using to wipe them down with then stick up like little ice picks waiting to get you good the next time you ran your hand down them, that is if the knife edge along the mag seam did not get you first. A little work with some 220 grit wet/dry got rid of the knife edge and the little shards at the welds could be raised with a small knife blade then broken off and dressed with the paper. However, that dressing also removed the finish from the mags in those areas, not that finish is that big a deal.
The mags other than this seem very nice but I still have not live fired them yet which I expect no further problems. Fit and feed with dummies is fine. However, this knife edge and weld burrs is something that caused a little cussing and blood shed and is not something I have encountered with aluminum mags or the PRI/DPMS steel mags.
Has anyone else noticed this knife edge and burrs on their mags?