Posted: 4/30/2015 8:36:01 AM EDT
[Last Edit: 4/30/2015 5:25:00 PM EDT by serdmann]
I built my rifle using the following parts. What if any can I add or remove/replace. Also if I sold this what would I be able to price this at?
White Oak 16" Barrel 1in 7 twist mid length gas system.
Cheely custom gunworks lower CCG-15
Vltor VIS-3 upper
Barrel is threaded for a muzzle device
St-t2 buffer with spikes spacer
Sprinco blue spring
BCM full auto carrier
BCM mod3 charging handle
Dueck Defense 45 offset sights
I added the lower receiver info into the post
This is my First build. Needed a lot of help from a lot of people and listened to quite a few more
welcome to the forum, have some crab meat
Your question is missing some info like,
what reciever you used and what your experience level is for assembling an AR15 pattern rifle
It sounds like you have some nice parts, and if you check the Equipment Exchange here
you can ascertain what the used parts might sell for individually.
The build looks solid from a parts perspective...
Is the barrel threaded for a muzzle device? I don't see one listed, The handguard used can add a bit of cost/value to the rifle as well.
Just know that resell on rifles is very, very low right now due to the post panic glut. There's always a sucker born everyday who will pay top dollar for that "custom" AR15, but most buyers in the know are aware that ARs are a dime-a-dozen right now.
Take the price you paid for all the parts, knock off 30-35% or so, that's what you could likely sell it at right now. Of all the things in my home, the last thing i'd consider selling right now is my ARs...prices are just too low. This should change with the next presidential election cycle, and even more so after/if Hillary gets elected.
welcome to the arfcom
Edited my first post with more pertinent info
Thanks for the info everyone
Not to worry Painless