Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 3/15/2005 8:38:32 AM EST
[Last Edit: 3/15/2005 8:38:49 AM EST by drop_zone]
Just finished my first build. RRA Car flat top upper with Stag lower and RRA parts. Finally got everything together and when I try and lock my bolt back it will not. Even with a empty mag in the well. If I pull down on the paddle it will lock. Should I put another Bolt release in. I dont see anything wrong and can just be a hair off, any ideas
Link Posted: 3/15/2005 9:11:06 AM EST
Have you tried a new mag? Is the mag seated fully / properly? Check your mag release... if you're not locked in fully this can happen (as I've found out)
Link Posted: 3/15/2005 11:19:53 AM EST
Yes mag is seated. Also with mag out when I push in the nipple it will not latch the bolt back. Tryed a different lower and it works fine
Link Posted: 3/15/2005 12:35:28 PM EST
You probably have the same problem as I have on one of mine. The bolt catch is binding. It may be either an out of spec lower, bolt catch or the rollpin is too tight.
Link Posted: 3/15/2005 4:56:30 PM EST

Originally Posted By millsusaf:
You probably have the same problem as I have on one of mine. The bolt catch is binding. It may be either an out of spec lower, bolt catch or the rollpin is too tight.



Ding ding ding.
Top Top