Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 2/22/2006 8:26:34 PM EDT
Ok I want to zero my iron sights using the IBZ, shown here.

Only problem is, instead of the 6/3 or 8/3, it starts at 0 and goes in increments of five. i.e. 5, 10, 15, 20, etc.

And there is no marked aperature. Is the big or small one the unmarked?
Link Posted: 2/22/2006 8:29:17 PM EDT
The small hole is the unmarked one
Link Posted: 2/22/2006 8:30:15 PM EDT
[Last Edit: 2/22/2006 8:48:51 PM EDT by M4A1OwnsYou]

Originally Posted By DM1975:
The small hole is the unmarked one



Alright thanks. That's the least of my worries though haha

Edit: Tried the screw thing too. I can't turn the wheel with the wrench still in the whole, so oh well.

I'll just bottom it out at 0, zero it in at 50 yds, and call it a day. then just play with the rear sight elevation when i switch distances.

Actually, I'll just start it off on 5, so it isn't as hard to turn, and to leave a little leeway.
Top Top