Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 8/24/2005 4:12:50 PM EDT
Should it rotate simply with finger pressure? Thanks
Link Posted: 8/24/2005 4:20:12 PM EDT
Link Posted: 8/24/2005 4:22:37 PM EDT
Sorry, I mean rear sight, windage.
Link Posted: 8/24/2005 4:27:24 PM EDT
Link Posted: 8/24/2005 7:38:59 PM EDT
I couldn't get mine to move with a 223 round. I had to use the smallest bit from my Benchmade torx set.
Link Posted: 8/25/2005 4:48:10 AM EDT
whatevers clever.

Link Posted: 8/25/2005 6:16:34 AM EDT
Use whatever works. I used a ballpoint pen. It's a "set it and forget it" sight, so it's not like you're going to have to change it very often.
Link Posted: 8/25/2005 7:08:36 AM EDT
Before you take it to the range to sight it in, soak it in a little CLP or other lubricant of your choice. Sight it in and wipe off the excess.
Link Posted: 8/25/2005 8:01:54 AM EDT

Originally Posted By Lancelot:
Before you take it to the range to sight it in, soak it in a little CLP or other lubricant of your choice. Sight it in and wipe off the excess.



+1 That's what I did and it helped quite a bit. Mine was a real bitch to work with before I did 'da soakin'
Link Posted: 8/25/2005 3:24:24 PM EDT
I put my shirt tail (cleaning patch or piece of fabric works too) over the wheel then used the old thumb, to rotate it in place. Once you get it set shouldn't need much if any adjusting.
Link Posted: 8/25/2005 4:18:19 PM EDT
.
Link Posted: 8/25/2005 4:21:39 PM EDT
i use a small allen wrench i found. i don't really use that sight much anymore however...
Top Top