Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Posted: 9/17/2009 8:48:02 AM EST
Do you need, or should you use some type of ant cease compound on the threads of the barrel nut when installing your barrel?
Link Posted: 9/17/2009 8:59:48 AM EST
I don't know if galling would ever be a problem, but if you've ever galled the threads on anything you'd kick yourself in the ass for not. Also, if down the road you decide to change something, good luck.
Link Posted: 9/17/2009 11:03:49 AM EST
I use some moly containing grease. Works well.

Have heard recommendations not to use anything containing graphite because it can cause corrosion problems in the aluminum. I use Brownells moly grease and it's good stuff.
Link Posted: 9/17/2009 3:52:05 PM EST
Any high temp moly grease works just fine..... I used a dab of the disc barke lube I had sitting around.
Link Posted: 9/17/2009 5:42:13 PM EST
I have some of this . It may be a little more than some moly grease found at a autoparts store, but it meets the mil-spec. It was recomended in an other thread a while back. Will it make a difference? probably not but for a few dollars more I think it was worth it.
Top Top