Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 9/19/2003 8:01:34 AM EST
For those who have installed the Badger Ordnance Stabilizer trapezoidal handguard, I have a question regarding re-installing a standard A2 front sight base. From the pictures that I've seen, it looks like the handguard side walls cover part of the gas block/sight base. Is it possible to press in the sight base pins, or would I have to go to a gas block/sight base w/ an allen screw type attachment?

Thanks, Harry
Link Posted: 9/19/2003 7:56:46 PM EST
I recently attached a Badger Ordnance fore-end on an upper. It has the Bushmaster VMatch gas-block; basically an A2 sight base with the triangle sight cut off. It seems that the Badger's top end is set back far enough to clear a standard A2 sight.
Link Posted: 9/21/2003 4:55:45 AM EST
agony, Thanks for the reply. I realize that the A2 sight in itself will clear the handguard, but I would like to know how hard it would be to allign a punch to the rear taper pin to install and/or remove the A2 sight base with the Badger handguard in place. Harry
Top Top