Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
10/20/2017 1:01:18 AM
9/22/2017 12:11:25 AM
Posted: 8/7/2005 1:04:31 PM EDT
I purchased an armorers wrench from bushmaster in hopes to use it to loosen/tighten my Phantom flash hider. It turns out that the "square" section that I thought that the FH would fit in, doesn't. What gives?

I was thinking of just going to the hardware store and picking up a small crescent but I want to be careful and don't want to damage the crush washer.
Link Posted: 8/7/2005 1:17:23 PM EDT
I used a 3/4" wrench on my A2 f/h the other day, and it didn't seem to mar or damage
the A2, washer, or barrel.

I'm not saying it's the right tool, but it might work for you until you establish if your Phantom
or wrench is out of spec? I think a crescent will be too wide.
Link Posted: 8/7/2005 2:26:06 PM EDT
the crescent wrench would give possibly rounding off the edges.


what i did to my dpms wrench was put a file to it until it fit
Top Top