Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 2/18/2016 8:11:24 AM EST
Im getting the larry vickers two point sling and was just looking for some good quality QD sling mounts
Link Posted: 2/18/2016 8:56:55 AM EST
Pretty broad question. Some info or photos of your rifle would be helpful to provide recommendations.
Link Posted: 2/18/2016 10:06:40 AM EST
Lots of choices from lots of quality manufacturers. It's going to boil down to personal preference. Gear Sector is my favorite.
Link Posted: 2/18/2016 11:22:01 AM EST
Again, pretty broad question. Are you wanting a QD mount on a rail system (and even then, picatinny or keymod or m-lok)? Are you looking for a QD mount for a stock? On the buffer tube? Or a QD mounted end plate for a lower receiver?

Currently I have a Magpul MS4 dual QD sling. I have a BCM QD end plate on my lower so no matter where I put my stock length wise the rifle doesn't hang too low. I also have a BCM QD sling mount for my KMR-A rail for when I want 2 point. This is what works for ME, gives ME what I want. Your results/needs may vary.
Link Posted: 2/18/2016 2:30:22 PM EST
yeah sorry about missing some details. I have a magpul ctr stock and a bcm kmr-a rail. Im looking for a rail mount and was going to use my stock for the other mount
Link Posted: 2/20/2016 1:27:46 AM EST
Discussion ForumsJump to Quoted PostQuote History
Originally Posted By tbotter20:
yeah sorry about missing some details. I have a magpul ctr stock and a bcm kmr-a rail. Im looking for a rail mount and was going to use my stock for the other mount
View Quote

BCM makes a keymod QD sling mount that mounts directly on two keymod holes.

Do you need a QD sling mount to be mounted on a picatinny rail?

Link Posted: 2/20/2016 8:24:43 AM EST
I prefer to have the sling attach to the rear of the receiver. I have a Noveske plate on one rifle and a Magpul on the other, they both work fine. Can't commend on a handguard mount, I use MLOK.
Link Posted: 2/22/2016 4:09:14 PM EST
Discussion ForumsJump to Quoted PostQuote History
Originally Posted By tbotter20:
yeah sorry about missing some details. I have a magpul ctr stock and a bcm kmr-a rail. Im looking for a rail mount and was going to use my stock for the other mount
View Quote
Arson Machine, Arisaka Defense, IWC...all make quality keymod QD sockets
Link Posted: 2/22/2016 7:41:20 PM EST
Link Posted: 2/24/2016 3:59:17 PM EST
No I just needed one for the keymod since my ctr stock has an attachment point built into it. Do you need two qd swivels to attach to the sling? one for the rail section and one for the stock?
Link Posted: 2/24/2016 8:18:11 PM EST
Top Top