Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 3/12/2006 5:31:07 AM EST
I'm in the design phase for a new varmint barrel and it looks like Pac-Nor is the lead. These barrels don't come with gas blocks.

My question is, how would I go about aligning a bolt-on gas block to such a barrel? What's the best way to locate the gas exit port on the barrel with the gas port on the block?

Link Posted: 3/12/2006 6:00:00 AM EST
there is usually a dimple on the barrel and on the gas block without the rear bolt installed there is a hole which lines up with it.

what i do is use that along with lines drawn where the gas port is along with measurements from the bbl. shoulder to the gas port.
Top Top