Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
1/22/2020 12:12:56 PM
Posted: 9/16/2009 11:26:35 AM EST
Is there a trick in adjusting the rear Troy BUIS sight?

I tried to move the wheel on the side and couldn't do it. It's solid!
Link Posted: 9/16/2009 11:53:09 AM EST
Does your sight have a slot on the windage knob? If so use a quarter to turn it. If there is no slot then find something to depress the dentent. I used a small punch but I think the tip of a bullet works.
Link Posted: 9/16/2009 5:29:41 PM EST
Thanks, I'll give it a shot later.

How do I adjust the front sight too?
Link Posted: 9/17/2009 4:53:40 AM EST
The front sight can be adjusted with a bullet tip.

You could also just get the tool, but the sights were designed to be adjusted without it.

- Jay
Link Posted: 9/17/2009 7:00:03 AM EST
My Troy is a bit older and most 5.56 bullet tips are too fat. I use a Bic pen to hold in the detent or just try to turn it REALLY hard and it will move. Some variants had longer pins which MUST be depressed to move the rear dial.
Top Top