Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 3/24/2006 11:26:19 AM EST
Hi guys,

I just picked up a RRA 9mm AR. It came with a standard single stage trigger. My problem is that the pull is super heavy. I know it will never be as smooth or as crisp as my RRA 2 stage but I was wondering if there is anything I can do to adjust it?

Can I, or a gunsmith lighten the pull on this trigger?
Link Posted: 3/24/2006 12:15:59 PM EST
15 Minute Trigger Job

I also cut the tang off the hammer to increase the speed and prevent light strikes on super-hard mil-surp primers.
Link Posted: 3/25/2006 1:37:31 PM EST
Wow, great link.

Thanks very much.
Link Posted: 3/27/2006 8:23:18 PM EST
[Last Edit: 3/27/2006 8:29:25 PM EST by stangleonthedangle]

NoAim, I really must thank you again for pointing me towards this thread. When I first fired my new rifle I was actually a bit upset about the heavy trigger. I followed the steps described and hit the range this morning and it shot like a dream.

Thanks again,

also, I would highly reccomend this modification to anyone.
Link Posted: 3/30/2006 6:10:13 PM EST
Link Posted: 3/30/2006 7:10:03 PM EST
Link Posted: 3/30/2006 8:09:02 PM EST
[Last Edit: 3/30/2006 8:09:37 PM EST by MaverickMkii]
Wow what a world of difference!

I just did that trigger job to my Bushy and it went from 3-stage, 8lb pull to crisp 5lb pull with almost no creep.

I don't think it gets any better if you want to stay stock!

Link Posted: 3/30/2006 8:26:11 PM EST
hmmmm interesting. I may just try this out.
Link Posted: 3/30/2006 8:29:26 PM EST
I have done it just recently also and recommend it. Except I didn't polish the parts, just dremeled with diamond bit like I used to do my 10/22. Very smooth and easy trigger now. Only complaint is the stock trigger travel is still there. No problem for a dremel either but you gotta draw the line somewhere for safety's sake.
Top Top