Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 10/9/2004 3:26:13 PM EST
How do you take the barrel off of a RRA 9mm CAR upper to have it chopped and threaded?
Thanks alot,
Jeremy
Link Posted: 10/9/2004 3:31:02 PM EST
Same as an AR15. Are you familiar with that? BTW, the build it yourself forum is probably the best place to ask this, those guys do their own gunsmithing.
Link Posted: 10/10/2004 4:25:34 AM EST
[Last Edit: 10/10/2004 4:26:38 AM EST by SBR7_11]
Just spin the barrel nut off and slide the barrel out of the uppers' bore.

Link Posted: 10/10/2004 9:16:23 PM EST
how do you do it exactly step by step with a new CAR NON FREE FLOAT TUBE upper???? ive never attempted this on ar.
Thanks
Link Posted: 10/11/2004 2:45:03 AM EST
Of course after you make sure the gun is unloaded and safe...

1. Remove the muzzle device
2. knock the pins out of the front sight
3. slide the front sight off
4. unscrew the barrel nut with an armorer's wrench
5. the barrel nut and delta ring assembly should slide right off over the naked barrel.

I did this with my 9mm, but I never actually removed the barrel. The only tools I used were the YHM barrel nut wrench, punches, hammer, and rubber mallot.
Link Posted: 10/11/2004 8:38:38 PM EST
Thanks alot Offspring.
Jeremy
Top Top