Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 10/25/2004 2:03:35 AM EST
I have a barrel that threads into a milled receiver and want to uses it for a stamped receiver. Does anyone sell threaded trunnions.
Link Posted: 10/25/2004 2:28:18 AM EST
I may be wrong here, but I think the standard practice is to turn the threads off the barrel and press it into a standard stamped trunion. I guess to answer your question...I have never seen a threaded, stamped trunion.
Link Posted: 10/25/2004 2:40:10 AM EST
Link Posted: 10/25/2004 3:44:11 AM EST
[Last Edit: 10/25/2004 3:46:17 AM EST by jss823]
thanks guys. What size do I have to take it down to. on the lathe. Looking at the barrel the end that goes into the trunnion only about an inch is threaded and the rest is smooth with a .905 diameter. Do I just take it down to that size. Where is a place to buy trunnions.
Link Posted: 10/25/2004 4:26:03 AM EST
Link Posted: 10/25/2004 12:18:30 PM EST
Again, unless I am mistaken the measurement is 22mm and 23mm for the RPK. Sound about right Campy?
Top Top