Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 3/23/2006 5:55:56 AM EST
I have a slant muzzle break I am going to put on a ak rifle after I thread the barrel. I noticed the notch for the retaining pin on the break itself is offset from the vertical by about 20 degrees. I looked at the replacement front sight bases at v-var (my sight base does not have a retaining pin hole) and they have the detent hole for the retaining pin right in the middle of the front sight, at vertical. If I put my brake on that front sight setup it would not be horizontal, it would be canted. I looked at various ak pictures on this site and all the slant break pics show them at horizontal. What gives?

Are there different detent plunger/retainer locations on front sight posts?
Should I not worry about getting the retainer/plunger setup done and just red locktite the break on?
Link Posted: 3/23/2006 6:09:24 AM EST
The slant brake should be at an angle. It is designed to counter act the recoil of the rifle climbing up to the right in full auto.
Top Top