Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 10/15/2003 1:04:53 PM EST
Once you have your AK(s) all clean, what do you use for lubrication and where?

Best regards, J
Link Posted: 10/15/2003 6:33:37 PM EST
[Last Edit: 10/17/2003 6:07:15 PM EST by msh]
A light film of Mobil 1, and a very light film of grease on the areas that show bright after a few hundred rounds.
Ed's Red to clean.
Rig Universal shaving brushed on the exterior.
Link Posted: 10/15/2003 7:51:41 PM EST
Lately FP10 or Clenzoil to clean/lube most, Tetra for grease.
My car lives on Mobil1 though :)
Link Posted: 10/17/2003 2:18:01 PM EST
TW25B oil and TW25B Grease.
Link Posted: 10/18/2003 8:29:25 PM EST
tetra grease for moving part such as the rail, the bolt carrier, and along the magazine intake section. i put some one the magazine release device also.

i usually pour 2 teaspoons worth of mobil 1 synthetic oil down the barrel. the oil will lube the barrel up the best way. a lot of oil will run through the receiver and lube everthing in sight. about 1 teaspoon will make it way out the back of the receiver. this is where a nice rag come in. i wipe the oil off and use this excess oil to wipe the exterior of the gun. the gun will be very oil, too oily to touch. this is how i like my gun to be. i dont take chance with rust. i put the gun in the tactical bag then. a few days later, i take it out and use a paper towel a wipe the gun dry. there will be some oil inside the case, but it will act as extra lube when i put the gun back in.
Link Posted: 10/18/2003 8:31:22 PM EST
i have a revolver since i was 14 and it has not seen any rust. i am 26 now. the gun was a gift. out in the country, kids get to use guns very early in life. my revolver is the s&w 629
Top Top