Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 5/24/2003 11:02:08 AM EST
I'm in the process of gathering my U.S. made compliance parts. Is there a difference between a 7.62 gas piston and a 5.45 one? Krebs' is the only one I have found that list two different ones.
Link Posted: 5/24/2003 1:23:09 PM EST
Link Posted: 5/24/2003 2:32:41 PM EST
I assume you've seen the pictures of them that Krebs has on their website. If not, check 'em out. The differences look fairly significant.

I just bought one from them, and it's a nice little piece. Not sure if they're much better than the cheaper ones from Tapco, but they do use good steel at Krebs.
Link Posted: 5/24/2003 4:06:43 PM EST
The Tapco piston for the '47 will work in the '74 without any modifications.
Top Top