Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 12/17/2005 6:48:35 AM EDT
[Last Edit: 12/19/2005 11:48:13 AM EDT by occaar]
Link Posted: 12/17/2005 10:51:23 AM EDT
No problem as long as the trunion holes were just threaded and not drilled to a larger diameter than original. When the rivet gets crushed it actually bites nicely into the threads. SangRun Hunter had a post related to this over on Gunco.net. I did the rivet build after tapping the front trunion holes on my Rommy build, only been shot about 500 times but all seems tight. As a side note, I F'd up a receiver and got a chance to remove a full set of rivets I had pressed in with the bolt cutter method. They were all as much of a pain as the ones were when I was removing the cut receiver sections from the kit!
Top Top