Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Posted: 4/18/2006 5:28:12 PM EST
I will be using original bulgy (metric) rivets, not the tapco ones that have thicker heads.
Thanks.
Link Posted: 4/18/2006 7:20:44 PM EST
Have you considered just making a pair yourself? They're really pretty easy to make if you have an angle grinder. You can pick one up for about $15 at Harbor Freight.
Link Posted: 4/19/2006 6:26:31 AM EST
I have a set of premade rivet squisher heads for a bolt cutter, and found that they were a bit short for the shorter rivets. I just used a scrap piece of bar stock, cut into a piece a bit larger than the rivet squeezer head, and sandwiched it between the rivet and the bolt cutter heads. Ive also seen some people weld an extra little piece on, but I dont have a welder.
Link Posted: 4/19/2006 8:14:28 AM EST
There's some on the EE right now, $35 plus shipping. IN the AK parts forum.
Link Posted: 4/19/2006 9:42:43 AM EST
Thanks! Found it!
Top Top