Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 8/16/2005 10:47:05 PM EDT
Where can I find a new gas block WITH THE BAYONET LUG?....
Link Posted: 8/17/2005 2:05:18 AM EDT
Link Posted: 8/17/2005 2:10:47 AM EDT

Originally Posted By ark-and-spark:
www.k-var.com/product.asp?0=216&1=237&3=246


www.k-var.com/images/AK-022.jpg




Kvar has been good to me. No complaints.

Max
Link Posted: 8/17/2005 2:15:43 AM EDT
Link Posted: 8/17/2005 10:41:30 AM EDT
SAR-1....
Link Posted: 8/17/2005 12:05:17 PM EDT
Yup, I had K-VAR send me one of those a month ago.

Brand new Romanian part. Retainer pin holes are undrilled. Well, the holes are started, as you can see in the pic, but they are only about 1/16" deep.
Link Posted: 8/17/2005 12:23:11 PM EDT
So if you were to drill the holes the rest of the way would it be considered a drop in replacement part, or are the holes kind of placed randomly?....
Link Posted: 8/17/2005 12:33:24 PM EDT
You'll want to line up the gas hole and make sure its straight up and down,then drill the holes and insert the pins.Originally,they use a metric size pin but you can use a standard size if you get the right pins for the bit size.AA-OK has the metric bits if you want to keep it original.
Link Posted: 8/17/2005 1:16:35 PM EDT

Originally Posted By JOHNO:
You'll want to line up the gas hole and make sure its straight up and down,then drill the holes and insert the pins.Originally,they use a metric size pin but you can use a standard size if you get the right pins for the bit size.AA-OK has the metric bits if you want to keep it original.



And if you think that the gas block will move while you drill, put some loctite on it before you move it into position
Link Posted: 8/17/2005 3:03:06 PM EDT
You'll also need to make sure that the pin holes either line up right on the old pin holes or can be drilled in a different spot, basically you don't want to elongate the existing pin holes ...
Top Top