Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
11/24/2017 4:44:23 PM
11/22/2017 10:05:29 PM
Posted: 10/5/2004 1:28:09 PM EST
I want to make a Krink pistol in 7.62 and I found this kit from K-Var.

www.k-var.com/product.asp?0=211&1=214&3=112

Is it hard to put together a kit when the barrel is not in the trunnion? All my kit builds have had the barrel attached to the trunnion. I would like to get this kit but it seems very expensive. Any thoughts?
Link Posted: 10/5/2004 2:14:54 PM EST
Link Posted: 10/5/2004 5:40:16 PM EST
FYI, that kit doesn't come with either the front or rear trunnions. Get the kit that includes these parts or you'll pay KVar out the wazoo for them.

_Disconnector_
Link Posted: 10/6/2004 1:31:34 AM EST
i got that same kit and had it built on a milled receiver
Link Posted: 10/6/2004 3:05:32 AM EST

Originally Posted By themadhatter:
www.gunsnet.net/album/data//500/77291404-med.JPG i got that same kit and had it built on a milled receiver



nice! which receiver and who did the build?
Link Posted: 10/6/2004 5:27:35 AM EST
Did that kit from K-Var have the trunnions included?

disconnector was right, the kit doesn't seem like it comes with the trunnions.

I think those trunnions are out of stock at K-Var but cost $60 a piece. Too rich for my blood.
Link Posted: 10/6/2004 5:31:18 AM EST

nice! which receiver and who did the build?

it's a firingline milled undfolder receiver the work was done by chis at www.ak103.com (akusa)
Top Top