Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Posted: 10/10/2005 11:54:26 AM EDT
So what AK will this stock mount on?

Is there any way to modify the reciever to accept this stock?

If so...how?

AK Stock
Link Posted: 10/10/2005 11:57:39 AM EDT
Fits a stamped receiver. You will need to drill out the rivets and remove the old trunnion, weld up the old trunnion holes, then drill and rivet the new trunion & cut a hole for the stock latch and install it.
Link Posted: 10/10/2005 2:18:58 PM EDT
What Dorsai siad...also, that set does not include any of the folding stock hardware which is almost impossible to find....unless you get a complete setup from the same seller.
Link Posted: 10/10/2005 2:23:22 PM EDT
Link Posted: 10/10/2005 8:21:38 PM EDT
its not that bad all you need is a dremiel and some small files,.. but you need to get the hard ware with the butt stock or it is worthless
Link Posted: 10/10/2005 11:09:47 PM EDT

Originally Posted By cruzie27:
its not that bad all you need is a dremiel and some small files,.. but you need to get the hard ware with the butt stock or it is worthless


And something to drill out rivets and re-rivet the new trunnion. I agree the cuts could be pretty simple with a template, and taking the time to do it right, but a dremel and files are not all that is needed.

It really is quite a bit of work. You need to cut all three rear edges of the receiver in different ways, drill at least three new small holes (two for the third rear rivet, and one hole for the forward latch pin), and three larger cutouts for the two latches.
Link Posted: 10/11/2005 5:35:13 AM EDT
[Last Edit: 10/11/2005 5:37:50 AM EDT by Jicky]
And from what I hear about the seller be ready to wait a long time since he ship's from Russia...

ETA: The heat shield is not even included in the lower handgaurd...BOOO!!!
Top Top