Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
11/22/2017 10:05:29 PM
Posted: 8/20/2004 11:12:11 PM EST
[Last Edit: 8/21/2004 9:47:29 AM EST by M4_Aiming_at_U]
Link Posted: 8/20/2004 11:19:29 PM EST


It does...look quite limp!
Link Posted: 8/20/2004 11:21:29 PM EST
I think its beyond Viagra for that stock, time for an implant.
Link Posted: 8/21/2004 1:54:29 AM EST
looks like someone did a piss poor job of fitting a stamped stock to a milled receiver..
Link Posted: 8/21/2004 2:16:24 AM EST
+1
Link Posted: 8/21/2004 5:11:46 AM EST
+1
Link Posted: 8/21/2004 6:21:48 AM EST
my kid could do better than that
Link Posted: 8/21/2004 6:32:44 AM EST
Its The Pencil Neck Stock!
Link Posted: 8/21/2004 6:49:46 AM EST
[Last Edit: 8/21/2004 6:50:12 AM EST by archer2]
If you look close, that is a MAK90 or a MAADI slant cut reciever with a standard european stock........they fit it so there would be no gap between the reciever and the stock.....now it looks droopy.

I have a MAADI and wanted to put a regular stock on it.......this is why I have to wait until I find the correct stock

archer2
Link Posted: 8/21/2004 7:14:33 AM EST
The original stock is too short and not steep enough to raise the rifle into a comfortable position.......thier usually too short and usually off cantor....I replaced mine with one I made that was longer and was angled enough to put the sites where I needed em.........ya....maybe thats it.
Link Posted: 8/21/2004 7:47:29 AM EST
Link Posted: 8/21/2004 7:51:32 AM EST
Model: Bulgarian SA93
Price: $1,000.00

$1K for a Bubbaized SA93? I don't think so.
Link Posted: 8/21/2004 7:58:21 AM EST
it's made for shooting down mountains. if you guys knew anything about AKs you would have realized that right away. probably made for some special forces unit somewhere.

<­BR>



Link Posted: 8/21/2004 1:27:06 PM EST

Originally Posted By Taipan:
I think its beyond Viagra for that stock, time for an implant.



Link Posted: 8/21/2004 1:36:48 PM EST
Link Posted: 8/24/2004 2:49:33 AM EST
That is a stock for a stamped receiver fitted to a milled receiver....

If you compare a stamped receiver stock to a milled receiver stock you will see that the angle of the cut-out for the upper tang is different.
The lower surface of the tang on the stamped receiver is "straight" while the lower surface of the tang on the milled receiver angles downward.

They obviously didnt go to the trouble to install the correct lower tang that milled receivers are supposed to have. I bet that stock is not secured very well.....

I once saw a milled MAK-90 fitted with a stock for a stamped AK, the end result looked identical to the AK in the picture.
Link Posted: 8/24/2004 9:54:47 AM EST
Kinda looks like a Thompson with the shape of that stock.....
Top Top