Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 8/20/2003 3:54:44 PM EST
Any of Y'all know anything about Briggs&Starttons Magnatron ignitions ? I just replaced the short block in my riding lawnmower, and I set the magneto pickup to flywheel distance the thickness of an index card. I get no spark, I tried again with the kill switch wire removed, still no spark ! Any help would be greatly appricated.
Link Posted: 8/21/2003 2:58:14 AM EST
When I work on my B&G, I set the magneto gap as close as I can. You may be a little far with the index card gap. Also, make sure all the surfaces are rust, dirt, and goo free. If they are dirty, a very fine grade of wet/dry or coarse steel wool will clean it up. I don't recommend putting any oil (as a rust preventative) on the surfaces since oil can act as an insulator.

Best of luck!
Link Posted: 8/21/2003 5:45:48 AM EST
Link Posted: 8/21/2003 8:16:47 AM EST
Check this out:
Link Posted: 8/21/2003 4:08:57 PM EST
Thank you one and all. I will give your advice a try.
Top Top